• Gather equipment, plug in your glue gun
  
• Gather the ribbons
  
• Take one the end of the orange ribbon and wrap it once around the wreath, starting at the 1 o'clock position.
  1 Black Wreath, Orange Black 1 1/2 inch Wired Ribbon
  
• Continue wrapping the ribbon around the wreath, leaving about a two-inch space between each.
  
• When you get to the 7 o'clock position, make sure to leave a little extra room because this is where the bow is going to go.
  
• Cut the ribbon and secure the end.
  

Make the Bow

• Gather the thin black ribbon, the thick black ribbon, and the remaining orange ribbon.
  
• Position the Bowdabra, so the word Bowdabra is facing you. Next, cut 6 inches of the thin black ribbon. Then, Insert the thin black ribbon vertically. This ribbon is the one that will be used to tie off the bow.
  Black 1/4 inch ribbon
  
• Cut about 24 inches of the orange ribbon and the wide black ribbon. Lay the orange ribbon in the Bowdabra horizontally and lay the wide ribbon on top of it. Together, fold the ribbons twice to make a bow. Make sure you leave a little ribbon on the bottom.
  Orange Black 1 1/2 inch Wired Ribbon, Black 1 1/2 inch Wired Ribbon
  
• Take the thin black ribbon and tie off the bow you made. When the tie is secure, you can remove the bow from the device.
  
• Use florist wire to secure the bow to the wreath. It should be at the 7 o'clock position.
  Florist Wire
  
• Fluff the ribbon so it looks nice on the wreath.
  

Decorate the Wreath

• Adding a small decorative pumpkin is an optional step that looks nice. Put some hot glue on the wreath at the 12 o'clock position.
  1 small Decorative Pumpkin
  
• Hold the pumpkin on the glue for about 20 seconds so it will be very secure.
  

Make a Hanger

• If you don't already have a wreath hanger, you can easily make one using more florist wire. Take about 12 inches of the florist wire, and at the 10 o'clock position, wrap it around the wreath securely. Then go to the 2 o'clock position and wrap the end tightly. In the middle of the wire, twist it to have a loop that you can use to hang the wreath when not in use.
  
• Your wreath is finished. It's ready to hang.
  
• Proudly hang the wreath where it can be enjoyed. Happy Halloween!
  1 Door wreath hanger